HME 6700HD, Installation Instructions Manual

Page: 22 / 68

EQUIPMENT INST
ALLA
TION
15
5.3.2 Mount Base Stations on Wall
Base stations should be mounted away from grease and large metal objects. They must be at
least 6 feet apart, less than 10 feet from an available electrical outlet.
5.3.3 Connect Base Station Power Supplies
Figure 5. Distance between base stations
Mount each base station on the wall as follows:
1. Hold the base station against the wall with its door open, and
mark the wall through the four screw holes on the back of the
cabinet (Figure 6).
2. Set the base station down, and drill four 3/16” holes at the
marked spots.
3. Insert the enclosed #6 screw anchors into the holes.
4. Drive the four enclosed screws into the anchors, leaving the
screw heads 1/8 inch away from the wall.
5. Mount the base station on the wall by placing the four screw
holes in the back of the base station over the four screws, sliding
the base station.
6. Tighten the screws to secure the base station in place.
7. If required, install an optional vehicle detector board inside base
station #1, see section 5.8.
Figure 6. Open base station
showing four screw holes
Connect a power supply to each base station and an AC electrical outlet according to the
numbered instructions shown in Figure 7. If necessary, refer also to the wiring diagrams on
pages 54-60.
NOTE:
Only power supplies provide with the system are to be used.
Figure 7. Power supply connection to base station
Sections
1 2 3 4 5 6 7 8 9 10 11 12