background image

Hydraulic Equipped BOQF10HYD

Hoses and fittings are not included with 

BOQF-

10HYD. 

Attach hydraulic hoses to the cylinder, 

connect to the auxiliary ports on your loader to 

operate the attachment lock
Hydraulic hose and fitting requirements:

• 

Good quality, 5800 psi max.

• 

Sufficient length to reach the auxiliary ports.

•  1/4 i.d. minimum.

• 

Cylinder hose bushing requires 7/16-20 or 

SAE#4” ORB fitting.

• 

Skid steer end: connectors to fit your auxiliary 

ports. 

Operation

When entering and exiting the skid steer loader be sure to observe any pre-start, starting and exit 

safety procedures outlined in your skid steer operator manual.

•  Manual Lock: 

push the attachment lock levers all the way down to ensure pins are fully retracted

•  Hydraulic Lock: 

Enter the loader, startup and use the hydraulic lock cylinder control to fully re-

tract the lock pins.

• 

Lower the lift arms and tilt the adapter forward.

• 

Drive the skid steer forward until the top edge of the adapter is completely under the top flange of 

the attachment.

• 

Tilt the adapter backward until the front edge of the attachment is slightly off the ground to ensure 

the mounting frame is tight to the adapter.

•  Manual lock

: stop the engine and exit the loader, pull up on the lock levers until they are fully en-

gaged in the locked position and lock pins fully extended.

•  Hydraulic Lock: 

Activate the hydraulic lock cylinder control inside the cab, ensure the lock pins 

are fully extended.

7/16-20 or SAE#4” ORB 

Locked

Unlocked

Pins shown fully extended

4

!

WARNING

Operational Hazard

At first use the hydraulic cylinders and hoses on this product may contain air or 

an 

air-fluid mixture. Failure to remove all the air from the hydraulic cylinders can 

cause dangerous uneven, jerky cylinder movement during use.

Summary of Contents for BOQF10 Series

Page 1: ...upplied with the adapter to ensure optimum per formance The BOQF10 manual lock features a secure spring loaded over the centre attachment lock The BOQF10HYD in cab controllable hydraulic cylinder ensures a dependable solid lock Your kit components may not be the same as the ones illustrated in this manual The proced ure outlined here applies to installation of all adapter variations and is to be u...

Page 2: ... could result Possible burns or poisoning from pressurized fluid injection Caution Only qualified personnel should perform installations and connections to the skid steers hydraulic system Caution Do not attach equipment that is beyond the capacity of the adapter to avoid personal injury and damage to the equipment This Safety Alert symbol means ATTENTION BE ALERT YOUR SAFETY IS INVOLVED The Safet...

Page 3: ...or complete pin removal procedure Remove the old attachment from the immediate work area Move the BOQF10 series adapter in its place and roughly align the hitch plate bushings on the adapter with the loader lift arm and tilt cylinder bushings Inspect the bushings for wear replace if necessary Find the new pins that came with the adapter and lightly coat them with grease Align the bushings and care...

Page 4: ...hydraulic lock cylinder control to fully re tract the lock pins Lower the lift arms and tilt the adapter forward Drive the skid steer forward until the top edge of the adapter is completely under the top flange of the attachment Tilt the adapter backward until the front edge of the attachment is slightly off the ground to ensure the mounting frame is tight to the adapter Manual lock stop the engin...

Reviews: