26
Lubrication:
!
CAUTION
Operational Hazard
Personal Protection Equipment
(PPE) is required when operating
or maintaining this machine.
SNL00001
Grease:
Inspect pivot points and components before each use. Unusual play or noise could be an indication of worn parts. Parts
replacement should be performed by qualified personnel.
To prevent premature wear the grease zerks on the BK should be greased every 20 hrs or more often with heavy use.
Hydraulic cylinder
pivots
Cutting arm pivot
This symbol indicates a grease zerk
location shown in the illustrations below.
• Lubricate with an good Lithium EP2 grease or
equivalent.
• Use a hand-held grease gun for all greasing, one shot
of grease is adequate.
• Wipe grease zerk with a clean cloth before greasing,
to avoid injecting dirt and grit.
•
Replace any broken zerk fittings immediately.
• If grease zerk will not take grease, remove and clean
thoroughly. Also clean lubricant passageway. Replace
fittings if necessary.
!
CAUTION
Operational Hazard
Be aware of sharp cutting
arm blades and tines. Cutting arm must
aways be stored in the up position. Use
caution and keep distance when walking
around the blades and tines.
SL00009H
Wrap Grab Assembly
Summary of Contents for BK48LF
Page 2: ...2 Notes ...
