Hivertec motionCAT HCPCI-MNT720M, User Manual

Page: 53 / 168

42
3.2 Communication Module HM-GN00G
There must always be one HM-GN00G communication module per HMG type slave to send and receive
Motionnet communication, and relay communication data to modules stacked within the same slave or other
slaves.
Refer to "2.4 HM-GU00G" for the communication module of HUG base slaves.
3.2.1 Specifications
Category Item Specifications Remarks
Basic
specification
ASIC for Motionnet control None
Communication data relay Relays communication data of one line to the next slave
Number of modules that can
be stacked
0 to 6
This is the number of modules that can be directly
stacked on this device for use
Safety feature Overcurrent protection
A PTC thermistor (poly switch) cuts the current when the
current flowing through its receiving terminal exceeds a
certain amount.
Environment
requirements
Power supply DC +12V to DC +24V
Consumption current Max
Typical
Temperature requirement 0 to 50 degrees Celsius without dew condensation
Module dimensions
(Excluding the
connector’s
projecting part)
Module: Depth 85mm × Height 105mm
Outer dimensions of the frame: Depth 110mm × Height 115mm × Width 14.2mm
Table 3.2-1 HM-GN00G communication module specifications
3.2.2 External Appearance
Figure 3.2-1 External appearance of HM-GN00G communication module
F
12
B
A
CDE
6 57
8
9 0
34
F
12
B
A
CDE
6 57
8
9 0
34
Module's receiving terminal (P24-IN)
Communication module POW ON indicator
Connector for Motionnet
communication (J1)
Connector for Motionnet
communication (J2)
Rotary switch for module ID setting
Communication settings switch
Cyclic
communication
indicator