Hitachi UX2 Series, Instruction Manual

Page: 278 / 300

Chapter 12. When Warning or Fault Occurs
12-2
This chapter describes what is displayed when a fault or warning occurs in this unit and how to check the
occurrence status and handle the warning or fault.
12.1. Display When Fault or Warning Occurs
● When a fault or warning occurs in this unit, the fault or warning lamp lights up.
● When a fault condition, which interferes with printing while the LCD screen backlight is off, or a warning
condition, which does not interfere with printing but requires maintenance occurs, the fault or warning
message appears in a window.
● When an operation error is made or processing judgment is prompted, a confirmation message appears.
(1) When a fault occurs
[Target Sensor Timer Out] fault screen
● When Reset is pressed after the cause is removed, the fault state is cleared, and the message is closed.
● When Close is pressed, the fault window is closed, but the fault state is not cleared. At this time, when
Fault is pressed in the status display area, the fault window appears again.
● However, when the unit is no longer in the fault state, you can clear the state by pressing Close.
Operating status
indicator lamps
The name of the fault
message is displayed.
The detail, cause,
and solution are
displayed.
Message No.