2 Unit installation
Transportation
SMGB0091 rev.2 - 11/2015
15
2
2.2 Transportation
!
D A N G E R
Do not put any foreign material into the RASC unit and check to ensure that none exists in the RASC unit before the installation
and test run. Otherwise, a fire or failure will occur.
2.2.1 Hanging method
When hanging the unit, ensure the balance of the unit, check safety and lift it up smoothly. Do not remove any packing
materials and hang the unit under packing condition with two ropes, as shown in the figure.
Do not remove the plastic band
or the corrugate paper frame
Pass the wire ropes
through each lifting hole in
the base as shown
Wire rope
!
C A U T I O N
• Apply two lifting wires on to the RASC unit, when lifting it by crane.
• For safety reasons ensure that the RASC unit is lifted smoothly and does not lean.
• Do not attach lifting equipment to the plastic band or the corrugated paper frame, because the ropes will slip or break the materials.
• Ensure that the exterior of the unit is adequately protected with cloth or paper.
•
Transport the products as close to the installation location as practical before unpacking.