37
Such as old cloth
Place a sheet or cloth
for protection first, and
then lay it back to drain
water.
Remove all foods or ice.
Remove the leg covers, and raise the
adjustable mounts.
Empty the water from the water supply
tank / ice tray.
Use a tape to secure the door / power
cord.
See “ Preparation before use ” for
installing the refrigerator in a new
location.
Pg.36
〜
37
Pull off the power plug.
There is no problem even just before moving.
Place a sheet or cloth for protection
when moving / transporting it.
To prevent damage to the floor material or water from
spilling out.
Make sure to hold the
handles when carrying it
with 2 persons or more.
Do not lay it down horizontally for
transportation (which may cause
failure of the refrigerator).
Transporting your refrigerator (transport for moving)
1
4
2
5
9
3
6
7
8
Plug the power cord.
You may plug in the power cord immediately after installing the refrigerator.
Use a wall outlet exclusively when connecting the power cord. (Alternating current 220 - 240V, rated 10A or more)
●
Check that the power plug or the cord is not wedged between the back of the refrigerator and the wall in order to prevent
the cord from getting hot.
Clean the inside of the refrigerator.
●
Wipe it with a soft, wet cloth, then finish with a dry cloth.
●
Wash the water supply tank, water filter, and ice tray with water.
※
Do not wipe off the lubricant applied to the drawer rail or the contact surface of the rail.
(The lubricant complies with the Food Sanitation Act)
※
When using it at the beginning, it may smell of plastic.
If you are concerned, ensure that the room is well ventilated. (Smell will gradually disappear)
4
3
Cooling inside the refrigerator starts.
●
It may take more than
4 hours
to cool the inside of the refrigerator, depending on conditions such as the ambient temperature or
storage state of foods.
It may take 24 hours or more in summer, etc.
Do not put ice cream, uncooled foods or perishable foods in it until the inside of the refrigerator is cooled well.
●
Perform “
Ice Maker Cleaning
” when using the automatic ice making function first.
Pg.51
〜
53
●
A series of ice making operation will start automatically after the inside of the refrigerator is cooled well.
(When using for the first time,
it may take 24 hours and more to make ice.
)
●
When the temperature inside the refrigerator is low, cooling may not start for about 10 minutes after inserting the power plug.
●
Rust proofing of the piping may be required.
When installing the refrigerator near the hot spring areas, industrial areas, near the sewer pipes, etc., its pipes may corrode due to
the sulfide gas. Consult your service agent.
The warranty does not cover failures due to gas damage, such as blackening of the pipes.
●
After inserting the power plug into a wall outlet, you will hear noise from the refrigerator, it is preparing for operation.
You may also hear a louder noise from the compressor or fan until the inside is cooled enough.
●
Do not peel off the seal on the back or plastics at the lower part of the side.
●
When a magnet or suction cup is attached on the side of the body or the surface of a door, it may leave a mark.
●
When you attach a paper sheet on the door surface in a high ambient temperature, dew may form on the door
surface, or the paper may absorb moisture.
Note
Stickers
Plastic parts (Left / Right)
BEFORE USE