2-6
●
Startup
Side direction
Gutter
Upper direction
Ink stream
Gutter entrance diameter
The ink stream should be
positioned at the center
of the gutter inlet.
Make sure that the ink stream is positioned at the center of the
gutter from the side and upper direction as shown in the following
figure.
5
If the ink stream is not positioned at the center of the gutter, perform step 1 to
stop the ink ejection operation, and then proceed as directed in Section 7.6,
Correcting a Bent Ink Stream and Clogged Nozzle.
●
When checking the ink stream position, wear protectors (goggles
and mask).
●
If the ink or makeup ink should enter your eyes or mouth,
immediately flush with warm or cold water and see a physician.
●
Before ejecting the ink, ensure that there is no person in the
direction of ejection. (The end of the print head must be placed in a
beaker or the like.)
WARNING
Install the print head cover.
●
If the "Cover open" fault is indicated, press the Erase message key.
6
Switch from "Standby" state to "Ready" state.
7
Enter the print target detection signal and verify the printing
results
(See Section 2.1.1, Strating an operation).
8
Press the Ready key.
Ink Jet Startup Confirmation
The ink jet will be turned ON.
Solution To turn the ink jet ON, press [Ready].
Ready
Cancel
Summary of Contents for PH
Page 288: ...2 K5253 1 ...
