Hitachi LP-WU9750B, User Manual, Page: 57 / 90

57
OSD Menu description
OSD Setting
•
Menu Position
You can use this function to designate which area on the picture the OSD Menu will appear. As
you can see from the diagram below, there are five positions where you can choose to have the OSD
Menu displayed. The default setting is “Center”.
•
Time Out
Choice one value to display OSD on the screen time.
•
Message Box
Machine will automatically display the input signal message on screen if you select on. If you don't
want to disable the message, please select off.
Infrared Remote
If you want to control the projector by Web, LAN or RS232. Suggest you set this function "Off" to
prohibit control the projector via the infrared remote control.
Remote ID
Use ▲▼ to set the remote ID, after input correct ID. Press "Enter" to recored the value. You can set
the remote ID by remote control directly - refer to " Page 33 : Remote control " -ID Set. for detail
message.
Note: This feature is disabled if the device is setting 00 to be the initial value.
Start up logo
You can use this function to have the projector display the HITACHI logo in the start up screen. Set
On to display the HITACHI logo during start up and Off to display a blank picture.
If you hope to disapper the logo while no input detect, you had better change setting as page 40 "No
Signal".
Trigger
The projector has one Trigger output. You can configure one devices connected to the projector via the
trigger ports to be automatically turned on when the projector is on. There will be a 2-3 second delay
prior to activation to prevent operation of this function when the user is choosing the desired aspect
ratio.
•
Screen Outputs 12V of power on Trigger when the user open the projector screen.
•
4:3 Outputs 12V of power on Trigger when the user chooses the 4:3 aspect ratio.
•
16:10 Outputs 12V of power on Trigger when the user chooses the 16:10 aspect ratio.
•
16:9 Outputs 12V of power on Trigger when the user chooses the 16:9 aspect ratio.