53
OSD Menu description
•
Bottom Left Corner
Press ▲▼◄► to correct the bottom left picture bias. Refer to Fig 11.
•
Bottom Right Corner
Press ▲▼◄► to correct the bottom right picture bias. Refer to Fig 11.
Blanking
•
TOP
Press ◄► on the remote control to adjust the top blanking area on the projected picture.
•
Bottom
Press ◄► on the remote control to adjust the bottom blanking area on the projected picture.
•
Left
Press ◄► on the remote control to adjust the left blanking area on the projected picture.
•
Right
Press ◄► on the remote control to adjust the right blanking area on the projected picture.
•
Reset
It will reset all the blanking functions to the default settings that is without any blanking functions
enabled.
Lotus
Lotus
Use Right and Top blanking function to
block the additional picture on the screen.
Edge blending
•
Status
Press ENTER to select ON or OFF. The function must be set to ON in order to enable the
function of Edge blending. If the function is set to OFF, the function of Edge blending is disabled.
•
Blending Region
→
Blending Region is to used to set the overlapped area at the four sides for blending
in multi-projection application. Adjusted lines, when enabled, will be shown for indicating the
overlapped area boundary. Press▲▼◄► to adjust the Blending Region at Top, Bottom, Left, Right
directions on the projected picture.
Note: As shown in the below drawing, the Blending Region area is the overlap area of the projected image 1 and
image2. The Blending Region lines that is set where the other projector last pixels ends.
Summary of Contents for LP-WU9750B
Page 69: ...69 Projector specifications Dimensions LP WU9750B 212mm 576mm 500mm ...
Page 89: ......
Page 90: ......
