Hitachi L200 Series, Instruction Manual

Page: 57 / 280

L200 Inverter
In
v
e
rt
er Mounting
and Installation
2–17
Terminal Dimensions and Torque Specs
The terminal screw dimensions for all L200 inverters are listed in table below. This
information is useful in sizing spade lug or ring lug connectors for wire terminations.
CAUTION: Fasten the screws with the specified fastening torque in the table below.
Check for any loosening of screws. Otherwise, there is the danger of fire.
When connecting wiring, use the tightening torque listed in the following table to safely
attach wiring to the connectors.
Wire the Inverter Input to a Supply
Step 6: In this step, you will connect wiring to the
input of the inverter. First, you must determine
whether the inverter model you have requires
three-phase power only, or if it can accept either
single-phase or three-phase power. All models
have the same power connector terminals [R/L1],
[S/L2], and [T/L3]. So, you must refer to the
specifications label (on the side of the inverter)
for the acceptable power source types! For
inverters that can accept single-phase power
and are connected that way, terminal [S/L2]
will remain unconnected.
The wiring example to the right shows an L200
inverter wired for 3-phase input. Note the use of
ring lug connectors for a secure connection.
Connector
Number
of Screw
Terminals
Models 002NF,
004NF, 005NF
Models 007NF-
022NF, 037LF,
004HF - 040HF
Models 055LF,
075LF, 055HF,
075HF
Screw
Diameter
Width
(mm)
Screw
Diameter
Width
(mm)
Screw
Diameter
Width
(mm)
Power Terminals 12 M3.5 7.1 M4 9 M5 13
Control Signal 16 M2 — M2 — M2 —
Alarm Signal 3 M3 — M3 — M3 —
Ground Terminals 2 M4 — M4 — M5 —
Screw Tightening Torque Screw Tightening Torque Screw Tightening Torque
M2 0.2 N•m (max. 0.25 N•m) M3.5 0.8 N•m (max. 0.9 N•m) M5 2.0 N•m (max. 2.2 N•m)
M3 0.5 N•m (max. 0.6 N•m) M4 1.2 N•m (max. 1.3 N•m) — —
6