Hitachi HVM Navigator V03-06, User Manual, Page: 178 / 312

3-82 Migration procedures
HVM Navigator User's Guide - Migration
For the actions in , see "Exporting CSV file" in "Registering/removing
migration WWN" in "Migration procedures".
For adding storage devices to HVM Navigator, see "Adding storage devices" in
"Registering/removing migration WWN" in "Migration procedures".
Prerequisite Setting
Fulfill the following conditions before the prerequisite settings.
•
When Storage Navigator Modular 2 CLI is installed on the management
server where you are operating HVM Navigator, check if Administration
mode is set for the Storage Navigator Modular 2 CLI. If so, remember the
password. On the other hand, when Storage Navigator Modular 2 CLI isn't
installed on the management server, install Storage Navigator Modular 2
CLI version 11.50 or higher on the management server. The other versions
aren't supported.
For installing Storage Navigator Modular 2 CLI, see Hitachi Unified Storage
Command Line Interface Reference Guide.
•
Check if there are the storage devices for which Password Protection or
Account Authentication is set. If so, remember the user ID and password
for each storage device.
•
Check that commands from another management tool aren’t logging into
the storage devices for which Password Protection or Account
Authentication is set. If so, you cannot operate their storage devices.