GS4000 Installation Guide Revision 4.00
520-10-026-30X
1-36
1.3.3 POW-HSDCE
This is the DC-48/60V power supply used for GS4000
-
80E2.
(1) Outer
Appearance
As for the LED, see Table 1.3-3.
Figure 1.3-3 Outer Appearance of POW-HSDCE
WARNING: TO MEASURE THE VOLTAGE AT A DC-POWERED DEVICE, THE END
TERMINAL IS ATTACHED TO POW
-
HSDCE. ONLY TRAINED ENGINEERS OR
MAINTENANCE SERVICE PERSONELL ARE ALLOWED TO MEASURE THE
VOLTAGE. TO AVOID A FIRE OR AN ELECTRIC SHOCK, DO NOT INSERT
SMALL PINS OR PAPER CLIPS INTO THE TERMINAL.
(2) LEDs
In the DC-48/60V power supply for GS4000
-
80E2, the action status is indicated by the
combination of the two LEDs as shown in Table 1.3-3.
Table 1.3-3 LED Indications on the POW
-
HSDCE Front Panel
Name
POWER
（
LED = Green
）
ALARM
（
LED = Red
）
Action Status
Power ON
Power OFF
Output voltage is normal.
Power OFF
Power ON
Output voltage is abnormal.
Power OFF
Power OFF
Power is OFF or the output voltage is abnormal.
（
Note
）
Note: There is the possibility that both POWER LED and ALARM LED are powered off depending on the type of trouble.
(3) Accessories
No accessories provided.
*
NOTE: DC cables must be prepared by the customers themselves.
LEDs
Circuit
Breaker
Mounting Screw
Terminal
Board
Cable Clamp
Handle
Terminal
Board Cover
Potential Tap
(Read the
Warning below.)
