Hitachi E-Compact Medium Power Series, Operation Manual, Page: 35 / 106

35 | 106
E-Compact Medium Power
# Parameter Position # Description / Functionality
1/9 Power Setup 1100 1/1 Changes the output power of the Equipment.
2/9 Transmitter Setup 1200
1/2 Automatic Level Control: On/Off
2/2 Ctr Mode: Active / Standby
3/9 Time and Date Setup 1300 1/1 Change the date, time and date format (dd/mm/yy or
mm/dd/yy)
4/9 Password Setup 1400
1/2 Enable / Choose new password
2/2 Disable Password
5/9 Alarms Mask 1500 1/1 Reflected Power – Set de Alarm Mask for Reflected Power
6/9 USB Host Access 1600 1/1 System Upgrade – Used to system upgrade via USB card.
7/9 Transistor Bias
Adjustment
1700
1/4 LDMOS Drain Voltage - The values are pre-set at the factory.
2/4 Carrier Amp. Current - The values are pre-set at the factory.
3/4 Peak Amp. Gate Voltage - The values are pre-set at the
factory.
4/4 Status: show the status exciter: (Active / Standby)
8/9 PA Temperature
Control
1800 1/1 Allows to set the operating temperature of the Powers
Amplifiers.
9/9 Control Mode 1900 1/1 Enable control module acess remote
[2000] - Main Menu
⇨
Measurements
[0000]
Main Menu
[1000]
Setup Menu
[2000]
Measurements
[3000]
System Alarms/
Log
[4000]
Remote Acces
The "Measurements" menu allows access to read the operating parameters of the equipment (read
only).
# Parameter Position # Description / Functionality
1/7 Power 2100
1/3 Programmed: Show the Programmed power measurement.
2/3 Forward: Show the value of Forward Output Power (Watts).
Reflected: Show the value of Reflected Output Power (Watts).
3/3 ALC Reference Voltage: Show the value (Volts).
2/7 Exciter Status - - Active / Fail
3/7 Drawers 2300 1/3 Drawers Measurements