--- 15 ---
Fig. 10
Fig. 9
If the drill chuck cannot be removed by striking the hex. bar wrench, do not strike the hex. bar wrench forcibly.
Remove the drill chuck according to the procedure specified in section 10-1-4.
(2) Removal of gears and spindles from the angle unit
Remove the Retaining Rings [605], then tap the end of the Angle Head Ass'y [612] to take out the spindle
pinion ass'y and the Spindle and Gear Set [613].
To remove the Pinion [603] and the Ball Bearing [604] from the Spindle [607], place the end surface of the
Ball Bearing [604] on a tubular jig and press down on the Spindle [607] with a hand press. (Fig. 10)
Loosen
Wrench [614]
Push
Flat Hd. Screw (A) (Left hand) M6 x 25 [1]
Spindle [607]
Hex. bar wrench
10-1-8. Angle attachment ass'y (optional accessory) disassembly
(1) Removal of the drill chuck from the angle unit
The drill chuck can be removed from angle unit in the same manner it was removed from the impact drill;
however, always remove angle unit from the impact drill before attempting to remove the drill chuck.
This will prevent damage of impact drill's gear. Use the Wrench [614] (open-end) provided to hold the angle
unit spindle before attempting to remove the drill chuck. (Fig. 9)
Ball Bearing [604]
Pinion [603]
Woodruff Key [606]
