Hitachi DS65MU01, User Manual

Page: 15 / 59

DS65MU01
8
2.3.2. ID Remote Control
You can set the remote control ID when you want
to use this remote control on one of several different
displays.
Press [ ID ] button. The red LED blinks twice.
1. Press [ID SET] button for more than 1 second to
enter the ID Mode. The red LED lights up.
Press the [ID SET] button again will exit the ID
Mode. The red LED lights off.
Press the digit numbers [ 0 ] ~ [ 9 ] to select the display
you want to control.
For example: press [
0
] and [
1
] for display No.1, press [
1
]
and [ 1 ] for display No.11.
The numbers available are from [ 01 ] ~ [ 255 ].
2. Not pressing any button within 10 seconds will exit
the ID Mode.
3. If an error pressing of buttons other than the digits
occured, wait 1 second after the red LED lights
off and then lights up again, then press the correct
digits again.
4. Press [
ENTER
] button to confirm. The red LED
blinks twice and then lights off.
NOTE:
• Press [
NORMAL
] button. The green LED blinks
twice, indicating the display is in normal operation.
• It is necessary to set up the ID number for each
display before selecting its ID number.