English
19
3. Disconnect the charger power cord from the receptacle.
4. Hold the charger tight and pull out the battery.
PRIOR TO OPERATION
1. Tool
mounting
For keyless chuck
(1) Mounting the bit
After inserting a driver bit, etc. into the keyless drill
chuck,
fi
rmly grasp the ring and tighten the sleeve by
turning it toward the right (in the clockwise direction
as viewed from the front). (See
Fig. 4A
)
○
If the sleeve becomes loose during operation, tighten
it further. The tightening force becomes stronger
when the sleeve is tightened.
(2) Dismounting the bit
Firmly grasp the ring and loosen the sleeve by turning
it toward the left (in the counterclockwise direction as
viewed from the front). (See
Fig. 4A
)
For chuck wrench
Always use a chuck wrench to install a driver bit
or drill securely. As three chuck wrench holes are
provided, tighten the chuck evenly. (See
Fig. 4B
)
2. Con
fi
rm that the battery is mounted correctly.
3. Check the rotational direction.
When the selector lever is set to the drill
rotates clockwise when viewed from the drill rear.
When set to , the drill rotates counterclockwise.
(See
Fig. 5
) (The and marks are provided
on the body)
CAUTION
When the trigger switch is depressed, the selector lever cannot be moved. Always
release the trigger switch to move the selector lever.
HOW TO USE
1. Switch
operation
When the trigger switch is depressed, the tool
rotates. When the trigger is released, the tool
stops. (
Fig. 6
)
CAUTION
○
While operating the driver drill, take care not
to lock the motor.
Tighten
Loosen
Ring
Sleeve
Fig. 4A
Tighten
Loosen
Chuck
wrench
Fig. 4B
mark
mark
Selector
lever
Fig. 5
Trigger switch
Fig. 6
000Book̲DN10DSA̲ChS.indb 19
000Book̲DN10DSA̲ChS.indb 19
2017/04/04 10:57:37
2017/04/04 10:57:37