Hitachi CP-X2011N, Operating Manual

Page: 49 / 253

40
SETUP menu
SETUP menu
From the SETUP menu, items shown in the table
below can be performed.
Select an item using the
▲ / ▼ cursor buttons, and
press the ► cursor button or
ENTER
button to
execute the item. Then perform it according to the
following table.
Item Description
AUTO KEYSTONE
Selecting this item performs the Automatic keystone distortion
correction. Projector automatically corrects vertical keystone
distortion due to the (forward/backward) setup angle by itself.
This function will be executed only once when selected in the menu.
When the slant of the projector is changed, execute this function again.
• The adjustable range of this function will vary among inputs. For
some input, this function may not work well.
• When V:INVERT or H&V:INVERT is selected to the MIRROR item
in the SETUP menu, if the projector screen is inclined or angled
downward, this function may not work correctly.
• When the zoom adjustment is set to the TELE (telephoto focus),
this function may be excessive. This function should be used when
the zoom adjustment is set to the full WIDE (wide-angle focus)
whenever possible.
• When the projector is placed on the level (about ±4°), this function
may not work.
• When the projector is inclined to near ±30 degree or over, this
function may not work well.
• This function will be unavailable when the Transition Detector is on
(
70
).
KEYSTONE
Using the ◄ / ► buttons corrects the vertical keystone distortion.
Shrink the bottom of the image Ù Shrink the top of the image
• The adjustable range of this function will vary among inputs. For
some input, this function may not work well.
• When the zoom adjustment is set to the TELE (telephoto focus),
this function may be excessive. This function should be used when
the zoom adjustment is set to the full WIDE (wide-angle focus)
whenever possible.
• This function will be unavailable when the Transition Detector is on
(
70
).
AUTO ECO MODE
Using the ▲ / ▼ buttons turns on/off the AUTO ECO MODE.
ON Ù OFF
• When ON is selected, the projector will always be set to Eco mode
at start-up regardless of the ECO MODE
(
41
) setting. An OSD
message “AUTO ECO MODE” will be displayed for tens of seconds
when the projector starts with this function activated.
(continued on next page)