Hitachi Copy-on Write SnapShot, User Manual, Page: 65 / 90

Operations Using CLI
A–7
Hitachi Simple Modular Storage Copy-on-Write SnapShot User’s Guide
•
3. Execute
aureplicationlocal
to restore the pair. Refer to the following
example.
•
V-VOL to P-VOL is restored.
Releasing SnapShot Pairs
To release the Snapshot pair and change the status to Simplex:
1. From the command prompt, register the subsystem to which you want
to release the SnapShot pair, then connect to the subsystem.
2. Execute the
aureplicationlocal
command release the pair. Refer to
the following example.
•
3. Execute
aureplicationlocal
to release the pair. Refer to the following
example.
•
The Snapshot pair is released.
% aureplicationlocal –unit subsystem-name –ss –refer
Pair name LUN Pair LUN Status
Copy Type Group
SS_LU0200_LU1001 200 1001 Split(100%)
SnapShot ---:Ungrouped
%
% aureplicationlocal –unit subsystem-name –ss –restore –pvol 200
–svol 1001
Are you sure you want to restore pair?
(y/n[n]): y
The pair has been restored successfully.
%
% aureplicationlocal –unit subsystem-name –ss –refer
Pair name LUN Pair LUN Status
Copy Type Group
SS_LU0200_LU1001 200 1001 Paired( 40%)
SnapShot ---:Ungrouped
%
% aureplicationlocal –unit subsystem-name –ss –simplex –pvol 200
–svol 1001
Are you sure you want to release pair?
(y/n[n]): y
The pair has been released successfully.
%
% aureplicationlocal –unit subsystem-name –ss –refer
DMEC002015: No information is displayed.
%