Hitachi CE50-10, Instruction Manual

Page: 24 / 194

1.3 Connection to the power supply
NOTICE
Do not place the power cable adjacent to a signal cable, as such a cable layout might cause equipment failure or
malfunctions.
Connect the power cable as shown in the following example.
Figure 1‒7: Power supply connection
Connecting to a power supply outlet
Firmly insert the power cable plug into an outlet
#
that has a ground pole.
Figure 1‒8: Connecting the power cable to an outlet
#
If the only option is to use an outlet that does not have a ground pole, use a grounded to non-grounded conversion
adapter and connect the green ground cable from the adapter to a secure and reliable ground of the building. Verify
that the connections of grounded to non-grounded conversion are correct before use.
Preventing the power cable from being inadvertently disconnected
To prevent the power cable from being inadvertently disconnected, secure it by using a retainer clamp, as shown in the
following figure.
When securing the power cable, make sure that the radius of the cable bundling is at least 40 mm.
1. Installing the CE50-10
8