USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS
- 26 -
procedures, please consult your VCR operating guide.
3. The remote control will remember the codes you have programmed in until the batteries
are removed from the remote control. After replacing the batteries repeat the entire
programming procedure stated above.
4. If your VCR does not have a power function, the remote will issue the CHANNEL UP
function.
PRECODED VCR BUTTONS
These buttons transmit the chosen precoded VCR codes.
EXCLUSIVE TV BUTTONS
These buttons are for operating the TV.
Click to see Remote.
USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS
Operating the pre-coded function for your cable box
This remote is designed to operate different types of cable boxes. You must first
program the remote to match the remote system in your cable box. (Refer to page 26)
1. Set the MULTI-PAGE select switch to"TV/CABLE".
2. Turn ON your cable box.
3. Aim the remote control at the front of your cable box.
4. While holding down the CABLE POWER button on the remote, enter the 2 digit
preset code that matches your cable box as shown on page 26. The remote will turn off
your cable box when the correct 2 digit preset code is entered. When this occurs, the
remote control is programmed for your cable box. If the cable box does not turn off after
5 seconds, try another 2 digit preset code.
5. The remote will now control your cable box.
NOTES:
1. If your cable box cannot be operated after performing the above procedures, this means
that your cable box codes have not been precoded into the remote.
2. In the unlikely event that your cable box cannot operate after performing the above
procedures, consult your cable box operating guide.
3. The remote control will remember the codes you have programmed in until the batteries
are removed from the remote control. After replacing the batteries repeat the entire
programming procedure stated above.
4. If your cable box does not have a power function, the remote will issue the CHANNEL
