Hitachi 37LD8700C, Instructions For Use Manual

Page: 9 / 48

- 8 -
Before Switching On Your
TV
Power Connection
IMPORTANT: The TV set is designed to op-
erate on 220-240V AC, 50 Hz.
• After unpacking, allow the TV set to reach the
ambient room temperature before you con-
nect the set to the mains.
Connections To The Aerial Input
Socket
• Connect the aerial or cable TV plug to the
Aerial input socket located at the rear of the
TV and connect the cable plug coming out
from the TV out socket located on the devices
(VCR, DVB-T etc.) to this socket as well.
How To Connect Other Devices
IMPORTANT: Switch off the TV before con-
necting any external device.
Sockets for external connections are at the
rear side of the TV. For connection of other
devices via Scart refer to the manuals of the
related devices.
Inserting Batteries In The Remote
Control Handset
• Remove the battery cover located on the
back of the handset by gently pulling down-
wards from the indicated part.
• Insert two AA/R6 or equivalent type batteries
inside. Place the batteries in the right direc-
tions.
• Replace the battery cover.
NOTE: Remove the batteries from remote
control handset when it is not to be used for
a long period.Otherwise it can be damaged
due to any leakage of batteries.
Switching The TV ON/OFF
To switch the TV on:
Your TV will switch on in two steps:
1- Connect the power supply cord to the sys-
tem. Press Power On/Off switch “ ” located
by the mains input socket . Then the TV
switches itself to stand-by mode and the led
on the front of the TV becomes Red.
2- To switch on the TV from stand-by mode ei-
ther:
Press a digit button on the remote control so
that a programme number is selected,
or,
Press the "
-P/CH " or " P/CH+ " button at the
right side of the TV or press the “P-” or “P+”
button on the remote control, so that last
mode switched off is selected.
By either method the TV will switch on and
the led becomes green.
To switch the TV off:
• Press the “ (stand-by)” button on the re-
mote control or On/Off switch at the right side
of the TV, so the TV will switch to stand-by
mode and the GREEN LED will become
RED .
To power down the TV completely, press
Power On/Off button at the rear side of the
TV, or,
Unplug the power cord from the mains
socket.
1-ENG-3730W-HL02126UK-37 INCH-(LG)-PEU_IDTV-NEW SOFT-50090756.p65 21.07.2006, 16:42 8