1. Mounting of locks in door frame
The lock is mounted in the frame in the mounting holes .
The holes are drilled and threaded as shown below. We
recommend you to use one of our adapter plates when re-
placing a lock with different hole pattern.
2. Adjustment of lock engagement and clearance
The door lock should be adjusted so that the latching bolt engage-
ment is 15 mm. According to standard EN81-20, the minimum per-
missible locking is 7 mm + movement with closed contact (approx.
2 mm). The locking engagement is adjusted by moving the lock in
the holes 1 (see Figure 1).
The lock is adjusted so that there is clearance at the latching bolt and
the door leaf in locked position. We recommend a clearance of 1-2
mm. If necessary, washer/distance bush can be placed between the
lock and the frame if the clearance is too large.
Figure 2
Approved positions
LO-30
Door lock LI-25
Reference
:
Installation instruction LI- 25
LI-25-H (right) and LI-25-V (left) are maintenance-free
freight lift locks for double swing doors.
The LI-25 comes with 1pc mounted KL-30 lock contact and
LI-25-H & V both uses KO-26 door contacts included in Kit.
Contents of packaging
1. Door lock
2. Pull rod
3. Linkage arm (LI-25)
4. Lock roller with shaft
5. KO-26 door contacts (2pcs)
6. Suitable contact bridges
Recommended tools
Screwdriver – Torx 20
Required material
2 screws M8x12mm with suitable washers.
I N S T A L L A T I O N I N S T R U C T I O N
1 OF 2
Figure 1
Distance between mounting holes
LI-25
Figure 3
Locking engagement and clearance viewed from the bottom of the lock
Picture showing right variant lock
1
3. Emergency opening function
i. Valid only to locks with triangle opening
Holes are drilled in the door frame for the emergency
opening function as shown in the figure below. The
hole should be at least 14mm in diameter and the tri-
angle should be recessed at least 3mm from the front
to meet the EN81-20 standard.
Figure 4 (i)
Emergency unlocking
