- 33 -
4.3 Upgrading with the FlashTool 0.7.0.2.exe
1
、
FlashTool 0.7.0.2 is a green program needing no installation. After Connect the
unit to your pc with a USB-to-serial port cable
，
run FlashTool.exe.
Please refer to
the following steps to set.
Set *bin file
Select Memory
Card
Select mode
of main chip
Communicate
port
Set
Flash
Baud Rate
serial port
Summary of Contents for ISDB-T
