11
(2) Dual Surface Units and Control Knobs (on some
models)
The surface unit has 2 cooking sizes to select from so you
can match the size of the unit to the size of the cookware
you are using.
(3) Location of the radiant surface elements and controls
The radiant control knobs operate the radiant surface
elements on the cook top as shown below.
(4)
Hot
surface
indicator
Comes
on
when
the
unit
is
turned
on
or
hot
to
the
touch.
Stays
on
even
after
the
unit
is
turned
off.
Glows
until
the
unit
is
cooled
to
approximately
150
°F
(5)
AFTER
COOKING
Do not touch the surface units until they have
cooled down.
The surface may be still be hot and burns may occur
if you touch the glass surface before it has cooled
down sufficiently.
Immediately clean spills on the cooking area to
prevent a tough cleaning chore later.
If cabinet storage is provided directly above the
cooking surface, make sure that the items are
infrequently used and can be safely stored in an
area subjected to heat. Temperatures may be
unsafe for items such as volatile liquids, cleaners, or
aerosol sprays.
(6) About the radiant surface elements
The temperature rises gradually and evenly. As the
temperature rises, the radiant element will glow red. To
maintain the selected setting, the element will cycle on
and off. The heating element retains enough heat to
provide a uniform and consistent heat during the off
cycle. For efficient cooking, turn off the element several
minutes before cooking is complete. This will allow
residual heat to complete the cooking process.
(7)
NOTE
Radiant
elements
have
a
limiter
that
allows
the
element
to
cycle
ON
and
OFF,
even
at
the
HI
setting.
This
helps
to
prevent
damage
to
the
ceramic
cook
top.
Cycling
at
the
HI
setting
is
normal
and
can
occur
if
the
cookware
is
too
small
for
the
radiant
element
or
if
the
cookware
bottom
is
not
flat.
(8)
Using
the
Warm
Zone
FOOD
POISON
HAZARD:
Bacteria
may
grow
in
food
at
temperatures
below
140°F.
NOTE
The
surface
warmer
will
not
glow
red
like
the
cooking
elements.
Always
start
with
hot
food.
Do
not
use
warm
setting
to
heat
cold
food.
Do
not
use
warm
setting
for
more
than
2
hours.
The
WARM
ZONE,
located
in
the
back
center
of
the
glass
surface,
will
keep
hot,
cooked
food
at
serving
temperature.
Always
start
with
hot
food.
Do
not
use
to
heat
cold
food.
Placing
uncooked
or
cold
food
on
the
WARM
ZONE
could
result
in
foodborne
illness.
To
turn
the
WARM
ZONE
on,
press
Warm
Zone,
press one
(Lo),
twice
(Med)
or
three times
(Hi)
.
To
turn
the
WARM
ZONE
off,
press
the
Warm
Zone
pad.
For
best
results,
all
foods
on
the
WARM
ZONE
should
be
covered
with
a
lid
or
aluminum
foil.
When
warming
pastries
or
breads,
the
cover
should
be
vented
to
allow
moisture
to
escape.
The
initial
temperature,
type
and
amount
of
food,
type
of
pan,
and
the
time
held
will
affect
the
quality
of
the
food.
Always
use
pot
holders
or
oven
mitts
when
removing
food
from
the
WARM
ZONE,
since
cookware
and
plates
will
be
hot.
NOTE:
The
surface
warmer
will
not
glow
red
like
the
cooking
elements.
The self-cleaning feature will not operate when the warm
center is on.
The cooktop indicator light will be on when any one or
more burners are in use, and the cooktop indicator light
will be off when all burners are off.