Hirschmann MS30, Power MICE, MACH 4000, OCTOPUS, User Manual

Page: 140 / 196

Operation Diagnostics
136
9.1 Sending traps
Layer 2 Enhanced with Layer 2 Professional
Release 1.0 10/05
V
The events which can be selected are:
Name Bedeutung
Authentication The Switch has rejected an unauthorized access attempt (see the
Access for IP Addresses
und
Port Security
dialog).
Cold Start The Switch has been switched off.
Link Down At one port of the Switch, the link to the device connected there has been
interrupted.
Link up At one port of the Switch, the link to a device connected there has been
established.
Spanning Tree The topology of the Rapid Spanning Tree has changed.
Chassis
encompasses the following events:
– Power Supply: The status of a supply voltage has changed (see the
System
dialog).
– Signaling Relay: The status of the signal contact has changed.
To cosider this event enable “generate Trap” in the
Diagno-
stics:Signal Contact 1/2
Dialog.
– An error has occurred in connection with the SNTP.
– A media module has been added or removed.
– The AutoConfiguration Adapter, ACA, has been inserted or removed.
– The value exceeded / fell below the temperature threshold.
Redundancy The status of the HIPER-Ring or the redundant coupling of HIPER-Rings
/ network segments has changed.
Port Security On one port a data packet has been received from an unauthorized
terminal device (see
Port Security
Dialog).
Bridge Although the BPDU guard function is activited at a port a BPDU was
received (see User Manual Redundancy under „Rapid Spanning Tree“).
Table 10: Trap categories