Hirschmann Manitex vSCALE D3, User Manual

Page: 24 / 60

Commissioning
4.3 Zero point adjustment of sensors
The system includes a service menu in which the zero point of the following sensors can be
adjusted:
ƒ
Main boom angle sensor > See chapter 4.3.1
ƒ
Slewing angle sensor > See chapter 4.3.2
ƒ
Main boom length sensor > See chapter 4.3.3
ƒ
Inclination sensor (X/Y) on superstructure > See chapter 4.3.4
The zero point adjustment is carried out during the initial commissioning of the crane and can be
carried out again as required (e.g. after sensor replacement).
Access to the adjustment menu is password-protected.
At any time by pressing the “HOME” function key. Return to SLI main menu
Abort
Calling up the Service menu from the SLI main menu:
> Password entry
Display
Service code
Code input:
select each digit of the code,
hold down key and use
rotary control to select digit,
then release key.
correction
Service code
confirmation
Service code
© 2012 Hirschmann Automation and Control GmbH · Mobile Machine Control Solutions · www.hirschmann.com
24
/59
50-700-19-2001_422175_en (Manitex)_Rev_B.doc / 2012-03-13 / Issue B / rk.