HIROSE ELECTRIC CO.,LTD.
ETAD-T0685-01
0
4
/
8
FORM HC0011-9-2
△
（２）
Crimping
①
Use our company’s applicator for crimping
②
Inspection before cimping
・
Before crimping, verify if any foreign matter is on the crimper and the anvil. If so, clear
it away.
・
When setting up the terminal, verify there is no interference between the terminal and
the terminal plate (Picture1). (In case of interference, the terminal cannot be set up
correctly.)
・
Verify the crimping data of the appropriate cable and, measure the C/H as shown on the
cross-section below.
When crimping, set the stripped coaxial cable by making the contact with the wire barrel and the
dielectric of the cable, as shown in the Picture1.
Picture1
Cable position at the crimping
【
Reference for the position of the cable
】
Wire barrel
Terminal plate
Jan.1.2022 Copyright 2022 HIROSE ELECTRIC CO., LTD. All Rights Reserved.
