Hioki SW9001, Instruction Manual

Page: 19 / 170

15
Installing the Module
2.2 Installing the Module
Thoroughly read “Before installing the module” (p. 5) beforehand.
The following settings are initialized when you install a new module into a slot or change the type of
module installed in a given slot.
• Connection method
• Shield switching
• Channel delay
• Scan list
Required items: Phillips screwdriver (No. 2), antistatic gloves
Front
1
1
Touch the GND terminal with
bare hands.
2
Wear antistatic gloves.
Rear
3
3
Turn off the device.
Front 4
Remove all the measurement
cables connected to the device
and module.
(To prevent electric shock and short
circuit of the measuring object.)
Blank panel
Screw
(M3 × 6 mm)
5
Loosen the two screws
(M3 × 6 mm) and then remove
the blank panel.
Store the blank panel and screws.
You need the screws when using the
device after removing the module.
2
Preparation for Measurements
HIOKI SW1001A961-04