Hioki SW9001, Instruction Manual

Page: 101 / 170

97
Message Reference
(3) Shield switching
Set and query the shield switching
Syntax Command
:SYSTem:MODule:SHIeld <
Slot No.
>,<
Shield wire connection
destination
>
Query
:SYSTem:MODule:SHIeld?
Slot No.
>
Response <Shield wire connection destination>
<Slot No.> = 1 - 3 (NR1) (SW1001)
1 - 12 (NR1) (SW1002)
<Shield wire connection destination> = OFF/GND/TERMinal1/
TERMinal2/TERMinal3/T1T3/SNS2L
OFF: Not connected
GND: Connected to ground
TERMinal1:
TERMINAL 1
, connect to LOW terminal
TERMinal2: TERMINAL 2 , TERMINAL 3 , connect to source LOW
terminal
TERMinal3: TERMINAL 3 , connect to sense shield terminal
T1T3:
TERMINAL 1
, LOW te
TERMINAL 3
, connect to sense
shield terminal
Description Sets the shield wire connection destination for each slot.
The settings vary depending on the module type.
When the shield switching is set, all relay is opened.
Module Parameter that can be set Connection destination terminal
SW9001
Off Not connected
GND GND
TERMinal1
TERMINAL 1
, LOW terminal
TERMinal2
TERMINAL 2 , TERMINAL 3 , source LOW
terminal
TERMinal3
TERMINAL 3
, sense shield terminal
T1T3
TERMINAL 1, LOW te TERMINAL 3,
sense shield terminal
SW9002
Off Not connected
GND GND
TERMinal1 TERMINAL 1 , LOW terminal
TERMinal3 TERMINAL 3 , sense shield terminal
Example
:SYST:MOD:SHI 1,GND
Connect the shield wire for
SLOT 1
to GND.
:SYST:MOD:WIRE:MODE? 5
OFF
The shield wire for SLOT 5 is not connected.
Note • When the connection method is selected, the shield switching is set to the specified
value. Set the shield switching again as necessary.
•The [ TERMINAL 1 , LOW te TERMINAL 3 , sense shield terminal (T1T3)]
shielding connection on the SW9001 should only be used when connecting a BT3562,
BT3562A series (BT3562, BT3563, BT3561A, BT3562A, BT3563A) and DM7275 series
(DM7275, DM7276) at the same time while the DM7275/DM7276 contact check function
is not operating properly.
• Specifying a slot without a module will result in an execution error.
• An execution error occurs during scan operation (command).
8
Communication Function
HIOKI SW1001A961-04