Hioki SW1001, Instruction Manual, Page: 65 / 164

61
LAN Interface
Communication condition settings
To be checked before setting
The settings are different when the device and external device are connected to the existing
network and when the device and a PC are connected to a new network.
Connecting the device to the existing network
The network administrator (department) needs to assign the following items in advance. Be sure to
assign them so that they do not overlap with other devices.
• Address settings of the device
IP address: ................................................................. ___.___.___.___
Subnet mask: ............................................................. ___.___.___.___
• Gateway
Whether or not to use a gateway: .............................. Use / Not use
IP address (if used): ................................................... ___.___.___.___
(Set to 0.0.0.0 if not used)
• Communication command port No. to be used: ___ (Default setting: 23)
Creating a new network using the device and a PC
(Using a local network that is not connected externally)
The addresses shown below are recommended if there is no administrator or you are responsible
for setting.
Setting example:
IP address Set sequential IP addresses as shown below.
PC: 192.168.0.1
First device: 192.168.0.2
Second device: 192.168.0.3
Third device: 192.168.0.4
↓
Subnet mask: 255.255.255.0
Gateway: OFF
Communication command port number: 23
8
Communication Function