Hioki SW1001, Instruction Manual

Page: 143 / 164

139
SW9002 Multiplexer Module (4-terminal pair)
Connector wiring diagram
SW9002 connector signal list
1
19
20
37
Pin No. Signal Pin No. Signal
19 Return CH6 L 37 Source CH6 L
18 Return CH5 L 36 Source CH5 L
17 Return CH4 L 35 Source CH4 L
16 Return CH3 L 34 Source CH3 L
15 Return CH2 L 33 Source CH2 L
14 Return CH1 L 32 Source CH1 L
13 Source CH1 H 31 Return CH1 H
12 Source CH2 H 30 Return CH2 H
11 Source CH3 H 29 Return CH3 H
10 Source CH4 H 28 Return CH4 H
9 Source CH5 H 27 Return CH5 H
8 Source CH6 H 26 Return CH6 H
7 Shield 25 Sense CH1 L
6 Sense CH1 H 24 Sense CH2 L
5 Sense CH2 H 23 Sense CH3 L
4 Sense CH3 H 22 Sense CH4 L
3 Sense CH4 H 21 Sense CH5 L
2 Sense CH5 H 20 Sense CH6 L
1 Sense CH6 H
When using the device as a 2-wire model, only sense CH1 to CH6 are enabled.
The measurement connector frame of the module is connected to the casing (metal) of the device
as well as the protective ground terminal of the power inlet (conductive).
11
Multiplexer Module