Hioki SW1001, Instruction Manual, Page: 139 / 164

135
SW9002 Multiplexer Module (4-terminal pair)
11.2 SW9002 Multiplexer Module (4-terminal pair)
Features
The SW9002 is a multiplexer module that can be attached to the SW1001 or SW1002 Switch
Mainframe.
• 4-terminal-pair 6-channel multiplexer
• It can be switched to 2-wire (sense channel only).
• The 4-terminal pair structure reduces electromagnetic induction (eddy current) in AC impedance
measurement and minimizes the influence on measured values.
• An LCR meter can be used with shield wire connection between sense and source H and L.
• It can be connected up to 2 instruments by switching the analog bus.
Specifications
General Specifications
Operating
environment
Indoor, pollution degree 2, altitude up to 2000 m (6562 ft.)
Operating
temperature and
humidity
Temperature 0°C to 40°C (32°F to 104°F)
Humidity 80% RH or less (no condensation)
Storage temperature
and humidity
Temperature −10°C to 50°C (14°F to 122°F)
Humidity Less than 40°C (104°F), 80% RH or less (no condensation)
40°C (104°F) or higher and less than 45°C (113°F), 60% RH or less (no
condensation)
45°C to 50°C (113°F to 122°F), 50% RH or less (no condensation)
Standards
Safety EN61010
EMC EN61326 Class A
Dimensions Approx. 25.5W × 110H × 257D mm (1.00"W × 4.33"H × 10.12"D) (excluding the projection)
Mass Approx. 196 g (6.9 oz.)
Product warranty
period
3 years
Relays, fuses, and connector: Not covered by the warranty
Accessory Instruction Manual
11
Multiplexer Module