Hioki SW1001, Instruction Manual

Page: 137 / 164

133
SW9001 Multiplexer Module (2-wire/4-wire)
Connector wiring diagram
SW9001 connector signal list
1
17
18
33
34
50
Pin No. Signal Pin No. Signal Pin No. Signal
17 Shield 33 CH11 H 50 CH11 L
16 CH10 H 32 CH9 L 49 CH10 L
15 CH9 H 31 CH8 H 48 CH8 L
14 CH7 H 30 CH6 L 47 CH7 L
13 CH6 H 29 CH5 H 46 CH5 L
12 CH4 H 28 CH3 L 45 CH4 L
11 CH3 H 27 CH2 H 44 CH2 L
10 CH1 H 26 Shield 43 CH1 L
9 Shield 25 CH22 H 42 CH22 L
8 CH21 H 24 CH20 L 41 CH21 L
7 CH20 H 23 CH19 H 40 CH19 L
6 CH18 H 22 CH17 L 39 CH18 L
5 CH17 H 21 CH16 H 38 CH16 L
4 CH15 H 20 CH14 L 37 CH15 L
3 CH14 H 19 CH13 H 36 CH13 L
2 CH12 H 18 Shield 35 CH12 L
1 Shield – – 34 Shield
For 4-wire, channel n and channel n+11 is a pair of source and sense.
The measurement connector frame of the module is connected to the casing (metal) of the device
as well as the protective ground terminal of the power inlet (conductive).
11
Multiplexer Module