Hioki SW1001, Instruction Manual, Page: 102 / 164

98
Message Reference
(4) Selecting the channel
Select and query channel
Syntax Command
[ROUTe]: CLOSe <
Slot and channel No.
>
Query
[:ROUTe]:CLOSe?
Response <Slot and channel No.>
<Slot and channel No.> = Slot No. × 100 + CH No.
A 3-digit number (or 4-digit number) is used to specify the channel.
Example: 208 (or 0208) when specifying channel 8 for SLOT 2 .
1112 when specifying channel 12 for SLOT 11 .
Description Closes the specified slot and channel. The channel that was closed previously is
automatically opened. You can use the *
OPC?
query to check whether close operation has
completed.
Example
:CLOS 0122
Channel 22 for
SLOT 1
is closed.
:CLOS?
905
Channel 5 for SLOT 9 is closed.
Note • Specifying a slot without a module will result in an execution error.
• An execution error occurs during scan operation (command).
Open all relays
Syntax
Command
[:ROUTe]:OPEN
Description Opens all channels. You can use the *
OPC?
query to check whether close operation has
completed.
Example
Command
:OPEN
Note Executing this command while scan operation is in progress will cause scan operation to
stop and all relays to open.
Set and query channel delay time
Syntax Command
:SYSTem:MODule:DELay <
Slot No.
>,<
Time/MIN/MAX/DEF
>
Query
:SYSTem:MODule:DELay?
Slot No.
>
Response <Time>
<Slot No.> = 1 to 3 (NR1) (SW1001)
1 to 12 (NR1) (SW1002)
<Time> = 0 to 9.999 (NR2) [s] (MIN:0, MAX: 9.999, DEF: 0)
Description Sets the additional delay time after relay operation (standby for the specified settling time
occurs).
After the delay time elapses, channel closing is completed.
The channel delay time can be specified for each slot.
Example
:SYSTem:MODule:DELay 1,0.01
Set the channel delay time for SLOT 1 to 0.01 s.
:SYSTem:MODule:DELay? 3
0.5
The channel delay time for SLOT 3 has been set to 0.5 s.
Note
• Specifying a slot without a module will result in an execution error.
• An execution error occurs during scan operation (command).