Hioki ST4030, Instruction Manual, Page: 68 / 256

60
LC and RC Values Area Judgments [LCRC AREA]
Manually creating the PASS judgment area
You can set the PASS judgment area manually. You can manually micro-adjust the PASS judgment
area after auto creation.
(Measurement screen) [MODE] > [SETTING] > [JUDGE] > [LCRC AREA]
2
1
1
Tap [HI-LO] to set the shape of the PASS judgment area.
(ON)
[LO][HI]
Sets the PASS judgment area threshold values using the upper and lower limit values of
the LC and RC values.
(OFF)
[POINT1] [POINT2] [POINT3] [POINT4]
Sets the PASS judgment area threshold values using the LC and RC values of the
rectangle’s zenith.
IMPORTANT
Adjusts the PASS judgment area directly by tapping the PASS judgment area in the LC and RC graph when
[LCRC AREA] tab is displayed.
(ON):
Adjusts the size of the rectangle by tapping and dragging the borders of the area rectangle.
(OFF):
Adjusts the zenith positions by tapping and dragging the zeniths of the area trapezoids.
2
Tap any of the following: [HI] [LO] or [LC] [RC] .
Set the PASS judgment area threshold values using either the upper and lower limit values of the LC and RC
values, or the LC and RC values at the rectangle’s zenith.