Hioki RM3545, Instruction Manual, Page: 346 / 364

Appendix 16 Measurement Leads (Options)
A34
To purchase any of the options, contact your authorized Hioki distributor or reseller.
Appendix 16 Measurement Leads (Options)
Model L2101 Clip Type Lead Model L2102 Pin Type Lead
These leads have clip tips. Four-terminal measure-
ments are provided just by clipping on to the measure-
ment target.
Overall length: approx. 1500 mm
Bifurcation-to-lead length: approx. 250 mm
Clippable diameter:
φ
0.3 to 5.0 mm
Even on flat contact points that cannot be clipped to,
or on measurement targets with small contacts such
as relay terminals or connectors, four-terminal mea-
surements are available by just pressing.
Overall length: approx. 1500 mm
Bifurcation-to-lead length: approx. 250 mm
Pin base:
φ
1.8 mm
Initial contact pressure: approx. 70 g
Total compression pressure: approx. 100 g
(Stroke: approx. 2 mm)
Model L2103 Pin Type Lead Model L2104 4-Terminal Lead
The tips have a four-terminal design developed for
floating-foot testing of ICs mounted on boards. Resis-
tance can be correctly measured even with small
measurement targets.
Overall length: approx. 1500 mm
Bifurcation-to-lead length: approx. 250 mm
Between pin bases: 0.2 mm
Initial contact pressure: approx. 60 g
Total compression pressure: approx. 140 g
(Stroke: approx. 1.3 mm) The SOURCE leads of this four-terminal lead set have
covered alligator clips, and the SENSE leads have
standard test probes. Use for measuring printed cir-
cuit board pattern resistance, and where SOURCE
and SENSE leads need to be connected separately.
Overall length: approx. 1500 mm
Bifurcation-to-lead length: approx. 280 mm
1500 mm
250 mm
Tip pin *
* Tip pins can be exchanged ahead.
250 mm
1500 mm
Tip pin *
* Tip pins can be exchanged ahead.
250 mm
1500 mm
280 mm
1500 mm