Hioki RM3545, Instruction Manual, Page: 266 / 364

Chapter 13 Specifications
258
(1) Resistance range switching function
(2) 100 M
Ω
range high-precision function
(3) Number of measurement digits selection function
(4) Low-Power Resistance Measurement function (LP)
(5) Measurement Current Switching
Functions
Mode AUTO/ MANUAL
(Automatically set to manual if the comparator or BIN function is turned on.)
Measurement Ranges LP OFF:
10 m
Ω
/ 100 m
Ω
/ 1000 m
Ω
/ 10
Ω
/ 100
Ω
/ 1000
Ω
/ 10 k
Ω
/ 100 k
Ω
/ 1000 k
Ω
/
10 M
Ω
/ 100 M
Ω
/ 1000 M
Ω
LP ON: 1000 m
Ω
/ 10
Ω
/ 100
Ω
/ 1000
Ω
(With the 100 M
Ω
range high-precision setting on, the 1,000 M
Ω
range cannot
be used. When using the MUX measurement terminal setting with the 2-wire
measurement method, the 10
Ω
and lower ranges cannot be used.)
Default setting Mode: AUTO, Measurement Range: 1000 M
Ω
Setting ON/ OFF
Default setting OFF
Number of measure-
ment digits selection 7digits/ 6digits/ 5digits (If the number of f.s. digits is less than the setting, the
number of f.s. digits will be used.)
Default setting 7digits
Operation Low-power measurement is performed by limiting the measurement current
and open voltage. (1000 m
Ω
to 1000
Ω
range)
Setting ON/ OFF
(With OVC on when LP is on and the contact improvement function fixed to off)
Default setting OFF
Operation The measurement current is limited during measurement.
(100 m
Ω
to 100
Ω
range)
Measurement current High/ Low
Default setting High
Range
Measurement current
High Low
100 m
Ω
1 A 100 mA
1000 m
Ω
100 mA 10 mA
10
Ω
10 mA 1 mA
100
Ω
10 mA 1 mA