Hioki RM3545, Instruction Manual, Page: 242 / 364

11.4 Auto-Exporting Measured Values (at End of Measurement) (Data Output Function)
234
Once measurement completes, the instrument can send measured values automatically as
data to a computer via its UBS or RS-232C interface.
There are two methods for sending data. For more information about how to switch
between the methods, see "Using the USB Interface" (p.221)
(1) COM mode
Data is output to serial communications (COM, RS-232C communication) verification
software or to a receiving program created by the user.
(2) USB keyboard mode (available only with the USB interface)
Data is written to a text editor or spreadsheet application as if it were being typed on
the keyboard.
When using USB keyboard mode, be sure to launch the text editor or spreadsheet
application and position the cursor where you wish the data to be written before output-
ting the data. Improper placement of the cursor will cause the data to be overwritten at
that point. Be sure to set the input mode to single-byte characters.
11.4 Auto-Exporting Measured Values (at End of
Measurement) (Data Output Function)