Hioki RM3542-50, Instruction Manual

Page: 22 / 234

1.2 Names and Functions of the Parts
16
Rear Panel
Serial Number
Shows the serial number.Do not remove this
label, as it is required for product support.
Connect the supplied power cord (p. 22).
See "Before Turning Power On" (p. 9)
Connecting the Power Cord
RS-232C Connector
The RS-232C interface can be used to connect to
a PLC or computer (p. 109).
It is also used to connect to a commercially avail-
able printer with a serial interface for printing (p.
89).
RS-232C Communications
Printer Output
GP-IB Connector
(RM3542-51 only)
The GP-IB interface can be used to connect to a computer
(p. 109).
GP-IB Communications
SET MONITOR Connector
Connect another instrument to compare the set-
tings of two units (p. 59).
See "Before Connecting to the RS-232C Con-
nector or SET MONITOR Connector" (p. 10)
Compare Two Instruments
EXT. I/O Connector
Connect to a PLC or I/O board to control
the measurement start time, and to ac-
quire the comparator results (p. 95).
See "Before Connecting EXT. I/O
Connector" (p. 9), "Before Measur-
ing" (p. 10)
External Control
Bottom
Panel
Stand
When using the stand
Extend the stand until it clicks into place.
Make sure to extend both legs of the stand.
Collapsing the stand
Fold in the stand until it clicks into place.
This instrument can be rack mounted.
See: Rack Mounting (p. A8)
Please retain the parts removed from this instru-
ment to be used again.