Hioki MR8880-20, Instruction Manual

Page: 69 / 300

3.3 Basic Operation
59
Chapt
er
3 Basic
Ope
rat
ing Procedures
3
About Measuring Operation
The operation differs depending on the measurement function (high speed or real time) and
setting conditions.
*1: When High-speed Function
*2: When Real-time Function
About Dead time
When [Repeat (Repeat Recording) ] is set to [Repeat]:
After measurement is performed for the recording
length (recording time) portion, time is needed for inter-
nal processing before measurement can be resumed
(dead time). Measurement is not performed during this
dead time.
When you want to split the data into files at arbitrary times without losing any data,
set
[Cont (Continuous Recording) ] to [On] and set [Split Save] of auto saving to
[On] .
The dead time cannot be eliminated when measurement is performed with the High-
speed Function. The measurement operation differs when measurement is per-
formed using the trigger function.
Continuous
Recording
[Cont]
Repeat Recording [Repeat]
[Single] [Repeat]
Specified
*1
or Off
*2
Specified (
*1
and
when measure-
ment stopped with-
in recording time)
or Off
*2
On
*2
______________
Press START key or wait until scheduled start time
Press STOP key or wait until scheduled end time
Stop
Measuring
Start
Measuring
Measuring
Recording length or
Recording time
Stop
Measuring
Start
Measuring
Measuring
Dead time
Recording length or Recording time
Stop
Measuring
Start
Measuring
Measuring
Recording length or
Recording time
Stop
Measuring
Start
Measuring
Measuring
Dead time
Recording length or Recording time
Stop
Measuring
Start
Measuring
Measuring
Dead time
Measuring