Hioki MR8827, Instruction Manual, Page: 244 / 436

239
Recording Settings
12.1 Recording Settings
Procedure
Press the STATUS key to open the Status screen, and then select the [Memory Div] sheet.
1
Enable the Memory Division function.
Move the cursor to [Memory Div] .
Select [On] .
Off Memory Division is disabled.
(Default setting)
On Memory Division is enabled.
1
2
3
4
5
2
Set the number of divisions.
Move the cursor to [Division] .
Set the number of blocks for division.
Default setting: 4
3
Set the recording length.
(This is linked to the recording length setting on the [Status]
sheet.)
Move the cursor to [Shot] .
Set the recording length.
The maximum recording length and number of divisions are
determined automatically according to memory capacity
and the number of channels used.
Setting Range: “Appendix 2.4 Maximum recording length
and number of divisions (Memory division function)”
(p. A7)
Memory Division, Waveform Calculation,
and Roll Mode cannot be enabled at the
same time.
When the number of divisions is 32,
the Start Block is 5 and the Used
Block number (number of blocks to
use) is 20
No. of Divisions
Start Block
Used Blocks (Purple)
About Recording
When a faster timebase is selected,
display, print and save operations are
not available during measurement.
Selecting the displayed screen for auto
saving lengthens dead time.
4
Set the start block.
Move the cursor to [Start Block] .
Set the block number at which to start recording.
Default setting: 1
5
Set the number of Used Blocks.
Move the cursor to [Use Blocks] .
Set the number of blocks to use.
Default setting: 1
To display any block on the waveform screen when finished measuring
Set the number of blocks to display (p. 240)
(This can also be set on the Waveform screen (p. 137).)
To display overlaid waveforms
Set the number of blocks for reference (p. 240).
Memory Division Function
12