Hioki MR8827, Instruction Manual, Page: 163 / 436

158
Set the Waveform Position (Variable Function)
8.6 Set the Waveform Position (Variable Function)
The waveform height and display position can be arbitrarily set along the vertical axis (voltage axis).
Precautions when using the Variable Function
• Verify that the vertical axis (voltage axis) range is set properly for the input signal.
• The vertical axis (voltage axis) range is unaffected by changes to the upper and lower limits made by
the Variable setting.
The following two setting methods are available:
• Set the displayed amplitude per division (1 div setting)
Set the amplitude to be displayed per vertical division and the zero position of the waveform on the
vertical axis (voltage axis).
Per Division: 1 V
Zero position: 0%
Normal Waveform Variable Function (Per-Division setting)
1 V
0 V
0 V
10 V
• Set the Upper and Lower Limits (Upper-Lower setting)
The upper and lower limits on the vertical axis (voltage axis) can be set to display the waveform
amplitude full-screen.
Upper Limit: 10 V
Lower Limit: 0 V
Normal Waveform Variable Function (Set Upper/Lower Limits)
0 V
10 V
0 V
10 V
Settings for the Variable function can be made for each individual channel, using the [Each Ch] sheet
accessed from the Channel screen (p. 159), or for all channels using the Display range window (p. 160).