Hioki MR8740, Instruction Manual

Page: 122 / 424

5.3 Send PRINT key
110
If the "Send Print Key" is executed by using Model 9333, the data are printed after the print range
and types are selected.
This is also useful to prevent inadvertent printing due to operation errors.
When performing waveform evaluation, the evaluation area will be printed at the same time.
To disable printing of the evaluation area, set waveform evaluation to [OFF]. (
⇒ p.296)
5.3 Send PRINT key
Procedure
To open the screen: Press the SYSTEM key
→
[Printer] sheet
1
Enable data selection at time of printing
Move the cursor to the [Select at print] item.
Select [Yes] .
Procedure
To open the screen: Press the DISP key
→
File screen
2
Start and stop the measurement.
Press the START key to start the measurement.
Press the STOP key to finish the measurement.
During measurement, printing is not possible. Measurement must be stopped be-
fore starting to print.
3
Select print contents and execute printing
If the "Send Print Key" is executed by using Model 9333, the GUI
[Select at print] is displayed at the right on the screen.
Select
When the selection (except for [Cancel] ) has been made, printing starts.
Whole
Wave Print all waveform data in internal memory of instrument. (default
setting)
A-B Wave Print only A/B cursor defined range of waveform data in internal
memory of instrument. (Memory Function and Recorder Function
only)
About Trig Print waveform data for 10 divisions before and after trigger posi-
tion. (Memory Function only)
List Print main settings.
Report Print the report.
See: "5.5.2 Report Print (A4 Size Print)" (
⇒
p.114)
• To output the waveform
data to the PC con-
nected via LAN
Model 9333 LAN Communicator
is required to be installed on the
PC to which the data is to be out-
put. For more information about
how to operate and configure
Model 9333 LAN Communicator,
in addition to install it on the PC,
see the instruction manual of
Model 9333 LAN Communicator.