Hioki LR8450, Instruction Manual

Page: 172 / 310

169
Controlling the System
Unit Measure Channel Trigger Alarm Calculation System
Initializing (resetting) the system
This section describes how to reset all settings to their factory defaults.
See "11.9 Settings after Initialization (System Reset)" (p. 290).
> >
1 1
2 2
3 3
1
Press the ENTER key while [Initialize...] is selected.
The settings window will open.
2
Select the checkboxes for the settings you wish to initialize.
Settings data Resets all non-LAN settings to their default values.
Unit registration information Deletes information for all registered wireless modules.
Waveform data Deletes waveform data.
Communication Resets LAN settings to their default values.
3
Press the ENTER key while [OK] is selected.
The settings will be initialized.
Press the ENTER key while [Cancel] is selected to close the window without initializing any
settings.
If you initialize module information and communications settings, you need to re-register all
wireless modules and re-configure the LAN settings.
Ordinarily, it is not recommended to initialize them.
7
Configuring System Settings