Hioki LR8450, Instruction Manual

Page: 100 / 310

97
Example Trigger Settings
Unit Measure Channel Trigger Alarm Calculation System
2.7 Example Trigger Settings
This section introduces some example trigger settings.
What you want to do
See
(in table below)
Capture data from the time the START key is pressed until the time the STOP key is
pressed
No.1
Capture data once for 1 min. starting from when the START key is pressed No.2
Capture data for 1 min. repeatedly starting from when the
START
key is pressed until 60
min. elapses.
No.3
Once the CH1 measured temperature reaches or exceeds 500°C, capture data until the
STOP key is pressed
No.4
Capture data starting when the START key is pressed until the CH1 measured
temperature reaches or exceeds 500°C
No.5
Once the CH1 measured temperature reaches or exceeds 500°C, capture data until the
temperature falls below 300°C
No.6
Once the CH1 measured temperature reaches or exceeds 500°C, capture data repeatedly
until the temperature falls below 300°C
No.7
Once the CH1 measured temperature reaches or exceeds 500°C, capture data for the
next 1 min.
No.8
Capture data for 1 min. before and after the CH1 measured temperature reaches or
exceeds 500°C
No.9
No.
Measurement screen Trigger screen
Repeat
recording
Recording
time
File splitting Trigger
function Timing
Trigger
conditions
Pre-
trigger
Start
trigger
Stop
trigger
1 OFF
Continuous
recording
OFF OFF – – – – –
2 OFF
Specified
time
0 hr. 1 min.
0 s
OFF OFF – – – – –
3 OFF
Specified
time
1 hr. 0 min.
0 s
ON
Segment
time: 1 min.
OFF – – – – –
4 OFF
Continuous
recording
OFF ON Start Start OR –
Condition
level: ↑
Level:
500°C
–
5 OFF
Continuous
recording
OFF ON Stop Stop OR – –
Condition
level: ↑
Level:
500°C
6 OFF
Continuous
recording
OFF ON
Start &
stop
Start OR
Stop OR
–
Condition
level: ↑
Level:
500°C
Condition
level: ↓
Level:
300°C
7 ON
Continuous
recording
OFF ON
Start &
stop
Start OR
Stop OR
–
Condition
level: ↑
Level:
500°C
Condition
level: ↓
Level:
300°C
2
Trigger Function