Hioki LR8400-20, Instruction Manual

Page: 129 / 300

5.4 Periodic (Timer) Measurements
117
3
5
Chapter 5 S
p
ecif
y
ing Crite
ria
for M
easurement
s
Make these settings to record at a specific time. Recording can be set to
repeat at specific intervals between the set start and stop times.
Before setting, confirm that the HiLogger clock is set to the correct
time. If not, reset the clock on the
[System] screen (p. 152).
5.4 Periodic (Timer) Measurements
Select the [Setting]
Screen.
Move to a setting item.
Apply
Open the setting options
for the item to be set.
Select from the listed op-
tions
1
2
Change 1's
digit
Change 10's
digit
Key Setting Procedure
1
Set the [Timer] to [On] . (default setting: Off)
2
Enable (set to [On] ) the desired timer setting items.
3
Set the year, month, day, hour, minute and second for the start or stop time.
To enter the current time as the start or stop time, select the clock mark ( ) and press
ENTER .
4
(When [Interval] is set to [On] )
Set the amount of time (days, hours, minutes and seconds) between
recording repetitions.
5
Press START .
[Wait Timer]
will be displayed at the bottom of the waveform screen.
Setting options:
Start Set the recording start time.
Stop Set the recording stop time.
Inter-
val Set the recording repetition interval.
This setting is enabled on when
[Repeat] is set to [On] (p. 54).
1
2 3
4
Setting Procedure