Hioki IM7580, Instruction Manual

Page: 96 / 340

88
Set Measurement Conditions for Sweep Points
4.4 Set Measurement Conditions for Sweep Points
Sets the measurement conditions for sweep points.
Setting is possible from the setting and editing of sweep points.
Reference: “4.3.3 Normal Sweep” (p. 82), “4.3.4 Segment Sweep, Segment Interval Sweep”
(p. 85)
4.4.1 Setting Measurement Signal Frequency
Sets the measurement signal frequency.
1
3
Input method can be switched
between [DIGIT] and [10-KEY] .

/

When setting with (each digit)
1
Set the frequency with

/

or with the numeric
keypad.
Settable range 1 MHz to 300 MHz

/

When setting with (each digit)
Holding down a digit key changes the value continuously.
Settable range 1 MHz to 300 MHz
[×10] Sets the measurement frequency to 10×.
[/10] Sets the measurement frequency to
1/10×.
1
2
To set the frequency with the
numeric keypad
Changing the unit: M (mega)/ k (kilo)
To set the frequency with the numeric keypad
[C] Repeats the input.
• Instrument key is enabled if a numerical value is input.
• Frequency is set on pressing the instrument key.
• If the value is set to more than 300 MHz:
The value is automatically set to 300 MHz.
• If the value is set to less than 1 MHz:
The value is automatically set to 1 MHz.
2
Press [EXIT] to close the measurement frequency
setting screen.
3
Press [EXIT] to close the advanced settings
screen.