Hioki IM7580, Instruction Manual

Page: 86 / 340

78
Sweep Measurement
4.3.2 Setting the Sweep Range
Set the sweep range.
• If the sweep parameter is V or I, [CENTER-SPAN] and [START-STEP] cannot be set.
• For segment sweep, only [START-STOP] and [INTVL MEAS] can be set.
• The sweep range settings differ depending on the sweep parameter ( [SOURCE] ) settings.
(p. 79)
• Setting is possible from the setting and editing of sweep points.
Reference: “4.3.3 Normal Sweep” (p. 82), “4.3.4 Segment Sweep, Segment Interval Sweep”
(p. 85)
Example: For normal sweep, set [START-STOP] in frequency sweep (with [SOURCE] set to [FREQ] ).
1
1
Press [SETUP] .
3
2
2
Press [LIST] tab.
3
Press [QUICK EDIT] .
4
5
* Each common numeric keypad
Changing the unit: M (mega)/ k (kilo)
4
Select [START-STOP] .
Refer to “Types of sweep range” (p. 75)
5
(1) Press
[START] .
(2) Use the numeric keypad* to set the start
value of sweep and press [Hz] .
(3) Press [STOP] .
(4) Use the numeric keypad* to set the end
value of sweep and press [Hz] .
[C] Repeats the input.
[CANCEL] Cancels the setting.
6
8
7
6
Press [NUM] to set the sweep points.
7
Press [LOG] to set log calculation for sweep
points.
8
Press [SET] to confirm the setting.