Hioki IM7580, Instruction Manual

Page: 145 / 340

137
Equivalent Circuit Analysis Function
4.9.5 Settings to Judge Analysis Results
You can judge whether estimation results fall within a predefined judgment standard using the comparator
function.
Setting the upper or lower limit value
You must set upper and lower limit values for the judgment standards before using the comparator
function.
1
2
3
4
1
Press [SETUP] .
2
Press [CIRCUIT] tab.
3
Press [COMP] .
4
Select comparator function ON/OFF.
[OFF] Disables comparator function.
[ON] Enables comparator function.
5 6
5
Select the constants to set judgment standard.
(1)
Press the cell corresponding to HI of any
arbitrary parameter.
(2) Set the upper limit value with the numeric
pad* and press [SET] .
Settable range -9.99999 G to 9.99999 G
* Each common numeric keypad
[-]
Inputs the unit with a minus (-) sign.
[×10
3
] Increases the prefix of the unit.
[/10
3
] Decreases the prefix of the unit.
[C] Repeats the input.
[CANCEL]
Cancels the setting.
6
(1) Press the cell corresponding to LO of any
arbitrary parameter.
(2) Set the lower limit value with the numeric
pad* and press [SET] .
Settable range -9.99999 G to 9.99999 G
If the setting is such that upper limit value < the
lower limit value, the values are automatically
switched and set.
7
Press [EXIT] to close the setting screen.
4
Analyzer Function